Back in the 1970’s, 50cc racing motorcycles all went over 100mph, even the slowest ones. They are not mopeds, but their pistons are the same size. All of the development to make the A55 meet 2006 US EPA Pollution Standards had the side effect of making more power.

Apparently Tomos has found a shape and size that silences the intake roar, houses the air filter, and somehow helps the engine breathe better at low to mid rpms. Anything else you do, like drilling holes in the air box, making the 17mm inlet tube 19mm, making it 15mm, or running a hi-flow foam filter, causes a noticible loss of accelleration and power. Flip the stock air box 180 degrees, so the outlet is facing out, instead of into the hole in the frame, and the bike looses power, about 1 mph. The still air in the middle of the frame is somehow easier for the engine to breathe in, than the moving air outside.

Put back the stock 55 jet and air box, but cut the “elephant trunk” off of the rubber connector between the carburetor and the air filter, and round out the rubber into a bell, instead of a reverse bell. MAGICAL AIR BOX: If you run it without the air box, and with a bigger jet, it goes maybe 1/2 mph faster, but looses a lot of low end torque, and climbs hills worse. Needle bearings on both rod ends, a third outer crankshaft ball bearing, splines for the clutch hub, make the Tomos A55 engine durable, efficient and also easy to service. Tapered curved directed nozzle transfer ports, low-friction, high strength cylinder wall, with big all aluminum cylinder for better cooling, oval venturi carburetor with multiple jets. The A55 is a low emission two stroke engine with modern technology. Shaun has done much research on enhancing the performance of the 2007 Tomos A55. The result was the A55 engine already is very efficient, so much that it was too powerful and needed an intake restrictor and a excessively big back sprocket to keep it under the legal limits of speed and power. The low-emission low-friction Tomos A55 stock engine is happy going 40-45 mph, all the time, for many thousands of miles, and occasionally hitting 50, with minimal modifications. If you want to go real fast, like over 45 mph, make noise, clouds of smoke, spend a lot of money, and leave a trail of blown-up engines and ruined parts, then you can read how to do that elsewhere. If you want a reliable, clean, safe, easy, cost-effective way to get power, or torque, read on. Roland Sands new Indian streamliner “The Spirit of Munro” Click here to see more. CABLES 100's are illustrated and specified.Hardware: metric bolts screws, nuts, washers.Pedals, cranks, pins freewheels, tensioners.Wheel parts: bearings axle and brake parts.

Shocks, seats, fenders and other frame parts.Engine Hardware: special nuts, pins, keys, shims, clips.

Locks, helmets, baskets license plate brackets oils, sprays, foot pegs.

New puch moped